Title: STUDY OF DIFFUSION PERFORMANCE AND PREPARATION TECHNOLOGY OF THE COLOURED PMIA FIBRE
Page Range: p.601-608
Author(s): Li-Qi Liu; Lei Chen; Zu-Ming Hu; Jun-Rong Yu; Jing-Zhu
File size: 440K
Download the pdf (subscribers only)
Buy the pdf (non-subscribers)
Journal: Polymers and Polymer Composites
Issue Year: ppc
Volume: 20
Issue No: No.7
Abstract
Poly(m-phenylene isophthalamide) (PMIA) fibre is a kind of aromatic polyamide fibre, which can be prepared by a wet-spinning method. In this work, the process conditions of spinning influenced the performance and structure of the coloured PMIA fibre, and these conditions included spinning speed, coagulation bath, etc. Because the diffusion coefficient was associated with the performance and structure, the ratio of solvent to coagulant could explain the reason of influence of the coagulation bath on the fibre. In this study, PMIA spinning dopes with Colour Inde Blue 60 were first commixed in a pressurizer and then spun into a coagulation bath under a pressure of around 0.3 MPa. At a coagulation bath temperature of 50 degrees C, pure or dope-dyed PMIA fibres were prepared by wet spinning, and then the spun fibres were extracted by an ultrasonic oscillation method. The effect of the jet stretch ratio and the temperature and concentration of coagulation bath on the ratio of diffusion coefficient of solvent to coagulator were analysed during spinning process of dope-dyed PMIA fibres. The properties and structures of coloured PMIA fibres were characterized by SEM. Finally the optimized spinning technology of the dope-dyed PMIA fibre was obtained. 19 Refs.
Related reading
More journal reading and science coverage connected to this topic.
Shear strength of concrete wide beams shear reinforced with GFRP plates
Title: Shear strength of concrete wide beams shear reinforced with GFRP plates Page Range: p.111-118 Author(s): Min Sook Kim; Joowon Kang; Young Hak Lee…
Residual strength and deformation recovery of RC beams strengthened with FRPs plates under the sustained load
Title: Residual strength and deformation recovery of RC beams strengthened with FRPs plates under the sustained load Page Range: p.119-126 Author(s): Dooyong Cho; Hoseong…
Reliability design and optimization process on through mold via using ultrafast laser
Title: Reliability design and optimization process on through mold via using ultrafast laser Page Range: p.1-8 Author(s): Hsiang-Chen Hsu; Shih-Jeh Wu; Wen-Fei Lin; Boen…