Title: DEVELOPMENT AND EVALUATION OF A DYNAMIC MOULD TEMPERATURE CONTROL SYSTEM WITH ELECTRIC HEATING FOR VARIOTHERM INJECTION MOULDING
Page Range: p.443-455
Author(s): Wang Guilong; Zhao Guoqun; Liu Jitao; Li Huiping
File size: 702K
Download the pdf (subscribers only)
Buy the pdf (non-subscribers)
Journal: Polymers and Polymer Composites
Issue Year: ppc
Volume: 17
Issue No: No.7
Abstract
A new variotherm injection moulding process in which electric heating and water cooling are used to dynamically change the temperature of the mould is reported. The feasibility and temperature response of the system are evaluated through numerical simulation and the simulation results used in the design of a mould for a 32-inch liquid crystal display panel. A variotherm injection moulding line is constructed to verify the simulation results and to examine the effect of the new variotherm injection moulding technology on part quality. 21 refs.
Related reading
More journal reading and science coverage connected to this topic.
Shear strength of concrete wide beams shear reinforced with GFRP plates
Title: Shear strength of concrete wide beams shear reinforced with GFRP plates Page Range: p.111-118 Author(s): Min Sook Kim; Joowon Kang; Young Hak Lee…
Residual strength and deformation recovery of RC beams strengthened with FRPs plates under the sustained load
Title: Residual strength and deformation recovery of RC beams strengthened with FRPs plates under the sustained load Page Range: p.119-126 Author(s): Dooyong Cho; Hoseong…
Reliability design and optimization process on through mold via using ultrafast laser
Title: Reliability design and optimization process on through mold via using ultrafast laser Page Range: p.1-8 Author(s): Hsiang-Chen Hsu; Shih-Jeh Wu; Wen-Fei Lin; Boen…